ADLINK ND-6067 - Manual (Page 131)

129
Enable/Disable Channel for
Multiplexing
$(Addr)5(ChannelVal)
6013,6017,
6018
6.3.6
Read Channel Status $(Addr)6
6013,6017,
6018
6.3.7
Read CJC Status $(Addr)3 6018 6.3.8
Enable/Disable CJC $(Addr)C(Status) 6018 (12) 6.3.9
Read Enable/Disable CJC Status $(Addr)D 6018 (12) 6.3.10
CJC Offset Calibration $(Addr)9(Counts) 6018 6.3.11
Span Calibration $(Addr)0
6013,6017,
6018
6.3.12
Offset Calibration $(Addr)1
6013,6017,
6018
6.3.13
Synchronized Sampling #**
6024
6.4.1
Read Synchronized Data $(Addr)9 6.4.2
Digital Input $(Addr)8 6.4.3
Analog Data Out
#(Addr)(OutData) 6021
6.4.4
#(Addr)(Port)(OutData) 6024
4 mA Offset Calibration $(Addr)0
6021 (10)
6.4.5
20 mA Offset Calibration $(Addr)1 6.4.6
Trim Calibration $(Addr)3(Counts) 6021,6024 6.4.7
Save Power On Analog Value $(Addr)4 6021,6024 6.4.10
Last Value Readback
$(Addr)6 6021
6.4.8
$(Addr)6(Port) 6024
Current Readback $(Addr)8 6021 6.4.9
Digital I/O Modules Functional Commands
Synchronized Sampling #**
6050, 6052,
6053, 6054,
6058, 6060
6.5.1
Read Synchronized Data $(Addr)4
6050, 6052,
6053, 6054,
6058, 6060
6.5.2
Digital Output
#(Addr)(ChannelNo)
(OutData)
6050, 6060,
6063
6.5.3
#(Addr)(Port)(Odata)
6056, 6058 #(Addr)(Port)(ChannelN
o)(BitData)
#(Addr)T(OdataA)(Odat
aB)(OdataC)
6058
Digital Input $(Addr)6 605x,606x 6.5.4
Set Programmable I/O Mode $(Addr)S(IOSts) 6058 6.5.5
Communication Module Functional Commands
Set RTS Status $(Addr)0(RTS Status) 6531 6.6.1