ADLINK ND-6067 - Manual (Page 29)

27
2.1.7 Installation
Software Utility
Software is not necessary for this module.
Equipments for Installation
A host computer with RS-232 port
RS-232 cable (DB-9 female)
DC Power supply (+10V~+30V)
Wires (shielded and grounded is recommended)
Installation Procedure
1. Make sure the host computer is power off.
2. Use RS-232 cable to connect ND-6520 with host computer.
3. Wire the power supply to NuDAMs.Note that the power supply should meet
the specification.
4. Wire other NuDAMs.
Application Wiring
Figure 2-6 Application wiring of NuDAM-6520
2.1.8 Programming
The ND-6520 is a communication module, it is not necessary to do any
programming.
Host
Computer
DATA +
DATA -
+Vs GND
+ DATA
- DATA
+Vs GND
Local Power Supply
+10 V to +30 V
+Vs GND
NuDAM
module ND-6520
RS-232 to RS-485/
RS-422 converter
RS-232