ADLINK ND-6067 - Manual (Page 133)

131
Read TTL Input Low Trigger Level $(Addr)1L 6080 6.7.24
Enable Alarm @(Addr)EA(CounterNo) 6080 6.7.25
Disable Alarm @(Addr)DA(CounterNo) 6080 6.7.26
Set Alarm Limit Value of Counter 0 @(Addr)PA(ArmData) 6080 6.7.27
Set Alarm Limit Value of Counter 1 @(Addr)SA(ArmData) 6080 6.7.28
Read Alarm Limit Value of Counter 0 @(Addr)RP 6080 6.7.29
Read Alarm Limit Value of Counter 1 @(Addr)RA 6080 6.7.30
Set Digital Output Values @(Addr)DO(DoData) 6080 6.7.31
Read Digital Output and Alarm
Status
@(Addr)DI 6080 6.7.32
Special Commands
Read Command Leading Code
Setting
~(Addr)0
601x,602x,
605x,606x,
6080,6531
6.8.1
Change Command Leading Code
Setting
~(Addr)10(C1)(C2)(C3)
(C4)(C5)(C6)
601x,602x,
605x,606x,
6080,6531
6.8.2
Set Host Watchdog / Safety Value
~(Addr)2(Flag)(TimeOut)
(SafeValue)
6021,605x,
606x,6531
6.8.3 ~(Addr)2(Flag)(TimeOut)
(SafeA)(SafeB)(SafeC)
(SafeD)
6024
Read Host WatchDog / Safe Value ~(Addr)3
602x,605x,
606x6080,
6531
6.8.4
Change Polarity ~(Addr)CP(Status) 605X,606X 6.8.5
Read Polarity ~(Addr)CR 605X,606X 6.8.6
Host is OK ~**
601x,602x,
605x,606x
6080,6531
6.8.7