ADLINK ND-6067 - Manual (Page 8)

vi
• Table of Contents
6.7.2 Read Input Mode.............................................................................. 197
6.7.3 Read Counter/Frequency Value in HEX Format ............................. 198
6.7.4 Read Counter/Frequency Value in DEC Format ............................. 199
6.7.5 Set Gate Mode .................................................................................. 200
6.7.6 Read Gate Mode .............................................................................. 201
6.7.7 Set Maximum Counter Value ........................................................... 202
6.7.8 Read Maximum Counter Value ........................................................ 203
6.7.9 Set Initial Count Value ..................................................................... 204
6.7.10 Read Initial Count Value ............................................................... 205
6.7.11 Start/Stop Counter ......................................................................... 206
6.7.12 Read Start/Stop Counter Status ..................................................... 207
6.7.13 Clear Counter ................................................................................ 208
6.7.14 Read then Clear Overflow Flag ..................................................... 209
6.7.15 Enable/Disable Digital Filter ........................................................ 210
6.7.16 Read Filter Status .......................................................................... 211
6.7.17 Set Minimum Input Signal Width at High Level ............................ 212
6.7.18 Read Minimum Input Signal Width at High Level ......................... 213
6.7.19 Set Minimum Input Signal Width at Low Level ............................. 214
6.7.20 Read Minimum Input Signal Width at Low Level .......................... 215
6.7.21 Set TTL Input High Trigger Level .................................................. 216
6.7.22 Read TTL Input High Trigger Level .............................................. 217
6.7.23 Set TTL Input Low Trigger Level ................................................... 218
6.7.24 Read TTL Input Low Trigger Level ............................................... 219
6.7.25 Enable Alarm ................................................................................. 220
6.7.26 Disable Alarm ................................................................................ 221
6.7.27 Set Alarm Limit Value of Counter 0 ............................................... 222
6.7.28 Set Alarm Limit Value of Counter 1 ............................................... 223
6.7.29 Read Alarm Limit Value of Counter 0 ........................................... 224
6.7.30 Read Alarm Limit Value of Counter 1 ........................................... 225
6.7.31 Set Digital Output Values .............................................................. 226
6.7.32 Read Digital Output and Alarm Status .......................................... 227
6.8.1 Read Command Leading Code Setting ............................................ 229
6.8.2 Change Command Leading Code Setting ........................................ 230
6.8.3 Set Host Watchdog Timer & Safety Value ....................................... 232
6.8.4 Read Host Watchdog Timer & Safety Value .................................... 236
6.8.5 Change Polarity ............................................................................... 240
6.8.6 Read Polarity ................................................................................... 241
6.8.7 Host is OK........................................................................................ 242
INITIALIZATION & INSTALLATION ..................................................... 243