ADLINK ND-6067 - Manual (Page 135)

133
6.2.1 Set Configuration
@Description
Configure the basic setting of NuDAM, including the address
ID, input range, baud rate, and data format. The new
configuration will be available after executing the command.
@Syntax
%(OldAddr)(NewAddr)(InputRange/OutputRange/TypeCod
e)(BaudRate)(DataFormat/ CheckSumFlag /DataFlag)<CR>
% Command leading code. (1-character)
(OldAddr) NuDAM module original address ID. The default address ID
of a brand new module is 01. The value range of address ID
is 00 to FF in hexadecimal.
(2-character)
(NewAddr) New address ID, if you don’t want to change address ID, let
new address ID equals to the old one. (2-character)
(InputRange) Define analog input range, refers to Table 6-1
for details. (2-character) 601x
(OutputRange) Define analog output range, refers to Table 6-2
for details. (2-character)
602x
(TypeCode) Type Code is fixed 40H for Digital I/O modules.
(2-character) 605x,606x,
6531
Type Code represents the input mode.
(2-character)
50: counter input mode
51: frequency input mode 6080
(BaudRate) Define communication baud rate, refers to Table 6-3 for
details. (2-character)
(DataFormat) Define checksum, integration time and output
data format, refers to Figure 6-1 for details.
(2-character)
601x
Define checksum, integration time and output
data format, refers to Figure 6-2 for details.
(2-character) 602x
(CheckSumFlag) Define check-sum status, refer to Figure 6-3
for details. (2-character) 605x
Define check-sum status, refer to Figure 6-4
for details. (2-character) 6080
(DataFlag) Define check-sum status, refer to Table 6-4 for
details. (4-character, WXYZ) WX is for module
system setting. YZ is for RS-232 configuration. 6531
(601x,602x,605x,606x,
6080,6531)