Labconco PURICARE Procedure Station Models 34812xx - Manual (Page 12)

Page 12 of 197
ADJUSTING THE BLOWER SPEED & FILTER GAUGE
Type A2 without airflow sensor
Press the or keys to adjust the blower
speed. The word ‘wait’ will flash until the
blower speed stabilizes. Press ‘OK’ to
accept the new setting.
CERTIFIER USE ONLY
Calibration mode:
Motor Speed Factor:
wait 900
950
UP/DOWN TO CHANGE, OK
TO NEXT, MENU TO LAST
80
CERTIFIER USE ONLY
Calibration mode:
Filter setup:
1. New Filter
2. Filter Not Changed
UP/DOWN TO CHANGE, OK
TO NEXT, MENU TO LAST
Press the or keys to select. Option # 1 will
reset the filter life remaining gauge to 100%.
Option # 2 will leave the gauge unchanged.
Press ‘OK’ to accept your choice.
The Logic will automatically
turn off and reset itself into
normal operation.