Labconco PURICARE Procedure Station Models 34812xx - Manual (Page 173)

Page 173 of 197
5. Using the Phillips screws and locking nuts provided, secure the UV ballast to the
module.
6. Wire the UV ballast into the wiring harness, following the wiring diagrams located
in Figure 2a-c.
7. Reattach the electronics module to the top of the cabinet before reconnecting
the electrical power.
8. Raise the sash, and install the UV lamp by rotating the lamp pins into the
sockets.
9. Lower the sash to fully closed position, plug in the unit, and turn the system
power switch to the "UV" position. The UV lamp will illuminate. Refer to the
user’s manual for further information regarding the proper operation and
maintenance of the UV light.