Labconco PURICARE Procedure Station Models 34812xx - Manual (Page 3)

Page 3 of 197
Table of Contents 3-9
Introduction 10
Contacting Labconco 10
Section One – Background Information
Accessing the Certifier’s Menu 11
Adjusting the Blower Speed & Filter Gauge (A2) 12
Adjusting the Blower Speed, Filter Gauge & Airflow Sensor (A2) 13
Adjusting the Blower Speed, Filter Gauge, Airflow Sensor & Alarm Setpoint (B2) 14
Logic Filter Life Gauge Operation and Resetting for Local Conditions 15
QuickCharts
Logic Type A2 Purifiers 16-19
Logic Type B2 20-23
PuriCare Procedure Stations 24-27
Identifying Logic Models 28
Identifying Logic Firmware Version 28
Serial Number Tags 29
Model Numbering System 30
Purifier Data Plate 30
Test Report 31
Section Two – Theory of Operation
Airflow Patterns 32
ECM Motor 33-34
Electronics 34-35
Section Three – Installation Requirements and Setup Procedures
Space Requirements 36
Clearance 36
Location Requirements 36
Exhaust Requirements 37
Electrical Requirements 37
Service Line Requirements 38
Connecting Service Valves to Flammable Materials 38
Connecting Service Valves to High Pressure Service 38
Unpacking the Logic 38
Moving the Logic 38
Removing the Logic from its pallet 39-40
Installing the Purifier on an Existing Work Surface 40
Installing the Purifier on a Labconco Base Stand 40-42
Connecting the Purifier to Service Lines 43
Optional Type A2 Exhaust Connections 44
Type B2 Exhaust Connections 44
Drain Valve Installation (optional) 45