Labconco PURICARE Procedure Station Models 34812xx - Manual (Page 134)

Page 134 of 197
Towel Catch Removal
Although not normally required, the towel catch can be removed for cleaning,
inspection, etc.
Note: The work surface of the cabinet and the towel catch must be thoroughly
decontaminated before removing either.
6. Remove the work surface as described above.
7. Lift the front end of the center support straight up to release it from the locating
pins (A). Set the support aside in the work area.
8. Remove the towel catch by pivoting the bottom out toward you (B).
9. Surface decontaminate the towel catch before removing it.
10. Reinstall the towel catch by sliding it back into position, ensuring that the two slots
on either end of the towel catch properly engage the rails on the rear of the duct, as
shown in Figure 8-19. Also ensure that the DOP Sampling Line (the clear tube with a
black cap) either passes through a hole in the towel catch, or passes along the
outside edge of the catch without being kinked.
Figure 8-19