Labconco PURICARE Procedure Station Models 34812xx - Manual (Page 138)

Page 138 of 197
Section Nine
Electrical System Service Operations
NOTE: In order to properly service the Logic, you must obtain a Logic Certifier
Kit, Labconco P/N 3858400. Qualified certifiers can obtain this kit by
contacting Labconco Customer Service Department at 800-821-5525.
Fluorescent Lamp
Lamp Identification
All Logics use dual fluorescent lamps. The lamp information is shown in Table
8-1. The code of the lamp part number is as follows:
F25T8 TL741
F = fluorescent lamp
25 = the lamp Wattage
T8 = the lamp mounting configuration
TL741 = the phosphor used in the lamp
Note: The phosphor of the lamp determines the color and intensity of
the lamp. Not matching the phosphor may affect the quality and/or
color of the light.
Table 9-1
Fluorescent Lamp Specifications
Model 34308 34300 34408 34400 34508 34500 34608 34600
Fluorescent Lamps (2 each) F25T8
TL741 F25T8
TL741 F32T8
TL741 F32T8
TL741 F40T8
SP41
F40T8
SP41
F40T8
SP41
F40T8
SP41
Fluor. Lamp Labconco Part # 9721901 9721901 9721900 9721900 9721903 9721903 9721903 9721903
Fluor. Ballast Labconco Part # 3838100 3838100 3838100 3838100 3838100 3838100 3838100 3838100
Fluor. Ballast Robertson Part # ISL332T
8MVW
ISL332T
8MVW
ISL332T
8MVW
ISL332T
8MVW
ISL332T
8MVW
ISL332T
8MVW
ISL332T
8MVW
ISL332T
8MVW
Changing the Fluorescent Lamp
1. Unplug the cabinet or turn the System Reset Switch, located on the top of the
cabinet, off.
2. Remove the front dress panel as noted in Figure 7-1.
3. Remove the fluorescent lamps by pulling the lamp sockets straight off each end of
the lamp, and releasing both lamps from the spring clips that secure them in place.
4. Install the new lamps by reversing the removal procedure.