Identifying logic models, Identifying logic firmware version – Labconco PURICARE Procedure Station Models 34812xx User Manual
Page 28
Page 28 of 197
IDENTIFYING LOGIC MODELS
The Logic platform Biosafety Cabinet can be identified readily by several external
features, as shown in Figure 1-1:
• Model number beginning with 34xxx-xx
• Touchpad on the right corner post
and
an airflow graphic on the left corner post.
• When the system reset switch is turned off and then on, the Logic logo appears
briefly on the LCD screen, as shown in Figure 1-2.
Figure 1-1
Logic Logo
Touchpad
Airflow Graphic
LCD Screen
IDENTIFYING LOGIC
FIRMWARE VERSION
The Logic firmware version can be identified on the bottom of the LCD screen during
initial power up, after turning the system reset switch, located on the front of the
electronics module off and then on, as shown in Figure 1-2:
Figure 1-2
Logic logo (seen on initial power up)
Software Version number