Labconco PURICARE Procedure Station Models 34812xx - Manual (Page 122)

Page 122 of 197
Figure 8-2
To reinstall the panel, reverse these
steps, ensuring that the plastic pin in
the top corners of the dress panel
properly engage the corner posts.
Side Panel Removal
Note: The side panel(s) must be taken off to remove the Logic from its pallet.
1. Remove and save the two Phillips screws on the front edge of the side panel.
2. Pivot the front of the panel away from the cabinet. Lift the panel straight up and pull
the panel straight away from the cabinet to release the rear of the side panel from
its hinge. See Figure 3-2a.
Side Panel Installation
1. Install the side panel by inserting both back panel hooks into the side panel slots.
2. Ensure both panel slots are completely seated on the hooks. See Figure 3-2c.
3. Pivot the front of the panel toward the cabinet. Secure the panel by installing and
tightening the two Phillips screws.