Labconco PURICARE Procedure Station Models 34812xx - Manual (Page 46)

Page 46 of 197
Section 4 -
Initial Operation of the Logic
This section will take you through the steps to begin initial operation of the Logic, with
an explanation the controls, display and options, in order to prepare the unit for its
initial certification.
System Reset Switch
The Purifier has a system reset switch for resetting the unit’s microprocessors. The
switch is located on the front of the electronics module, on top of the unit, as shown in
Figure 4-1. Ensure that the switch is in the on (up) position before attempting to
operate the Logic.
Figure 4-1
The System Reset
switch