Labconco PURICARE Procedure Station Models 34812xx - Manual (Page 40)

Page 40 of 197
Figure 3-2c
Installing the Purifier on an Existing Work Surface
Note: The Purifier is very top heavy. Use caution when lifting or moving it.
Note: The Purifiers weigh from 400 to 700 pounds. Always use safe lifting
practices when picking it up.
When installing the Purifier onto an existing work surface or benchtop, ensure that the
structure can safely support the combined weight of the cabinet and any related
equipment. The work surface should be at least as wide as the unit and 31 inches deep
to properly support the unit.
The work surface should be smooth and durable. The surface should be nonporous and
resistant to the disinfectants and chemicals used in conjunction with the Purifier. This
will allow a proper seal to form between the bottom of the Purifier and the work surface.
A hole or notch may need to be cut in some work surfaces in the right front corner to
accommodate the drain valve.
Installing the Purifier on a Labconco Base Stand
Labconco offers a variety of accessory base stands in a number of configurations to suit
the user’s particular needs. Stands can be ordered with preset telescoping legs or, with
a manually or electrically adjustable hydraulic lift stand.