Labconco PURICARE Procedure Station Models 34812xx - Manual (Page 47)

Page 47 of 197
The Logic Information Center Layout
The Purifier's Information Center is an LCD display located on the right side wall at eye
level. The center’s display is divided into three separate areas, as shown in Figure 4-2,
below.
Figure 4-2
Status Area
Data Area
Icon Area
Status Area
The Status area displays the system status during operation. This line can display any of
the following messages:
OK
The motor is operating properly, and the sash is not open too far.
Sash is too high
The sash is open too far for proper operation.
Airflow Alert
The airflow patterns of the cabinet have been changed, resulting in a sudden
change in the motor speed. This is most likely due to a blockage of the grille or the
exhaust filter outlet. It may also be caused by removal of the work surface while the
cabinet is in operation.
System Error
The motor and display circuit board are not communicating properly. DO NOT USE
THE CABINET UNTIL THE PROBLEM HAS BEEN CORRECTED.