Labconco PURICARE Procedure Station Models 34812xx User Manual
Page 185
Advertising
![background image](/manuals/738628/185/background.png)
Page 185 of 197
Locate the connector and wiring that is part of the existing harness inside the electrical
control box, (see the picture below) and connect to J1.
3) Re-secure the electrical control box to the top of the Logic.
4) Connect the computer interface cable, # included in the kit to the J2 connector,
and connect the other end of this cable to a 9-pin serial input of a computer.
Proceed to the directions “Using the RS-232 Receptacle”.
Advertising
This manual is related to the following products: