Optional ultraviolet lamp, Lamp socket replacement, Lamp identification – Labconco PURICARE Procedure Station Models 34812xx User Manual
Page 139: Uv lamp specifications
Page 139 of 197
Lamp Socket Replacement
1. Unplug the Logic
2. Remove the dress panel as noted in Figure 7-1
3. Remove the fluorescent lamps from the sockets.
4. To replace a socket, insert a small straight bladed screwdriver into the socket
near the lamp wire, as shown in Figure 9-1.
5. Press the wire into the new socket.
6. Reassemble the unit.
Figure 9-1
Optional Ultraviolet Lamp
Lamp Identification
All Logics use a single 30-Watt germicidal lamp. The lamp information is shown
below. The code of the lamp part number is as follows:
G30T8
G = germicidal lamp
30 = the lamp Wattage
T8 = the lamp mounting configuration
UV lamp Specifications
• For all models, the UV lamp number is G30T8. The Labconco part number
is 1271300.
• For all 115/230 VAC models, the ballast assembly is Labconco part
number 3829901. The ballast is Robertson part number
PSM2GPH18MVW.
• For all 100 VAC models, the ballast assembly is Labconco part number
3830600. The ballast is Robertson part number RSO1GPH30100.