Altera JNEye User Manual
Page 159
Transmitter Tab
Figure 3-7: Transmitter Settings
Set the following parameters in the Transmitter tab:
• Transmitter: Stratix V GX
• Package: Stratix V GX
• VOD Selection: 40 (~800 mV)
• Pre-emphasis: Auto
• PLL Type: ATX (LC)
• PLL Bandwidth: Low
• Jitter/Noise Component:
• If the Altera Device Characterization Data Access function is enabled, click Characterization Data
Access. (A message box appears. Read and close the message box.) Transmitter jitter figures are
populated automatically and the jitter/noise modeling mode is selected.
• If Altera Device Characterization Data Access is not available, manually type in the jitter numbers
shown in the above figure. Note that the simulation results might differ slightly if the jitter data is
from manual input.
3-8
Setting Up the Control Module
UG-1146
2015.05.04
Altera Corporation
Tutorial: PCI Express 8GT