Altera JNEye - Manual (Page 36)

• Jitter/Noise Component mode—JNEye uses a flat jitter/noise structure that assumes no overlapping
among all the jitter and noise components. Avoid double counting when inputting or importing jitter/
noise figures. In the following figure, there are six specific jitter components: DCD, ISI, SJ, BUJ, RJ,
and jitter PDF. The noise components DN, BUN, RN, and noise PDF must also be specified separately.
Figure 2-18: Specifying Transmitter Jitter and Noise in Jitter/Noise Mode
Figure 2-19: Transmitter Jitter/Noise Configuration in Jitter/Noise Component Mode
2-30 Jitter/Noise Component
UG-1146
2015.05.04
Altera Corporation Functional Description
Send Feedback