Altera JNEye User Manual
Page 163
Perform the following steps to add the first crosstalk channel:
1. Click Channel in the Link Designer panel and select Far-end Crosstalk (FEXT).
2. Use the file browser to locate the channel model file Demo.s12p and add it to the channel list as FEXT.
3. The JNEye Channel Wizard displays the FEXT #1 characteristic. Note that the Crosstalk Aggressor
Location 1 is selected in for this channel.
4. Click OK to close the Channel Wizard.
5. Place the channel icon in the Link Designer.
Figure 3-11: First Far-end Crosstalk Configuration in Channel Wizard
Perform the following steps to add the second crosstalk channel:
1. Click Channel in the Link Designer panel and select Far-end Crosstalk (FEXT).
2. Use the file browser to locate the channel model file Demo.s12p and add it to the channel list as
second FEXT.
3. The JNEye Channel Wizard displays the first FEXT channel characteristic by default.
4. Change the Crosstalk Aggressor Location to 2. This tells JNEye to select the second FEXT in the12-
port S-parameter.
3-12
Constructing the Channel
UG-1146
2015.05.04
Altera Corporation
Tutorial: PCI Express 8GT