Altera JNEye - Manual (Page 165)

Figure 3-13: Complete Link Connection in Link Designer
The link configuration is complete. Use the Save/Save as buttons to save the configuration for later use.
Related Information
Link and Simulation Setting on page 2-6
The Link and Simulation Setting tab sets the global link parameters and simulation configurations.
Analysis
Use the Channel Viewer to observe and analyze the channel characteristics. The Channel Viewer button
is located on the right side of the Channel tab. This example shows the Sdd21 of the three channels you
selected as well as the channel responses at test points and the overall channel. You can leave the Channel
Viewer module open or close it by clicking OK or Exit.
3-14 Analysis
UG-1146
2015.05.04
Altera Corporation Tutorial: PCI Express 8GT
Send Feedback