Altera JNEye User Manual
Page 96
Advertising
Figure 2-72: Transmitter Reference Phase Noise Analysis (At Receiver Output)
TX pre-emphasis, de-emphasis, or FIR coefficients are displayed with the transmitter output.
The CTLE setting is displayed for the test point after CTLE.
DFE coefficients are displayed for the test point after DFE.
Time Interval Error (TIE) Plots
TIE plots capture the time differences between the waveform transition time (across data sensing
threshold) and ideal/reference waveform transition time. If Jitter Analysis is enabled and the simulation
mode is Hybrid, jitter analysis results are displayed under the TIE plot.
2-90
JNEye Data Viewer Module
UG-1146
2015.05.04
Altera Corporation
Functional Description
Advertising