Crosstalk aggressor transmitter setting, Crosstalk aggressor transmitter setting -73 – Altera JNEye User Manual
Page 79
Launch JNEye Batch Simulation Controller to run the generated link simulations (refer to the JNEye
Batch Simulation Controller section for details). The following figure shows the generated batch channel
simulations added in the JNEye Batch Simulation Controller and ready for batch simulations.
Figure 2-57: Added Generated Batch Channel Simulation Configuration in JNEye Batch Simulation
Controller
Related Information
•
•
JNEye Batch Simulation Controller
on page 2-129
Crosstalk Aggressor Transmitter Setting
Aggressor transmitter configurations allow you to configure crosstalk aggressors individually with
different transmitter types, pre-emphasis settings, amplitudes, data rates, and so forth. The following
figure shows a 3-aggressor link with three different aggressor transmitters.
UG-1146
2015.05.04
Crosstalk Aggressor Transmitter Setting
2-73
Functional Description
Altera Corporation