Yaskawa P7 Drive User Manual - Manual (Page 85)

Programming 5 - 1
Chapter 5
Basic Programming
This Manual contains descriptions of all user accessible parameters contained in the Drive.
Parameters are listed in alpha-numerical order. Parameter number and name, along with a
detailed description and its settings are described on the following pages.
A1 Initialization.................................................................................. 5-2
b1 Sequence..................................................................................... 5-4
b2 DC Braking .................................................................................. 5-9
b3 Speed Search .............................................................................5-11
b5 PI Function................................................................................. 5-15
b8 Energy Savings.......................................................................... 5-24
C1 Accel/Decel ............................................................................... 5-25
d2 Reference (Speed Command) Limits......................................... 5-26
d3 Jump Frequencies ..................................................................... 5-27
E1 V/f Pattern ................................................................................. 5-28
E2 Motor Setup............................................................................... 5-31
F6 Com OPT Selection ................................................................... 5-32
H3 Analog Inputs ............................................................................ 5-33
L2 Momentary Power Loss Ride-thru Function............................... 5-39
L3 Stall Prevention .......................................................................... 5-40
L4 Speed Command Loss Detection .............................................. 5-43
L5 Fault Restart .............................................................................. 5-44
L6 Torque Detection........................................................................ 5-46
L8 Hardware Protection .................................................................. 5-48
o1 Monitor Configuration ................................................................ 5-50
o2 Key Selections ........................................................................... 5-54
o3 Digital Operator Copy Function ................................................. 5-56
T1 Auto-Tuning ............................................................................... 5-59