Epson Pro L30002UNL 30,000-Lumen HDR Pixel-Shift DCI 4K Laser 3LCD Large Venue Projector (White) - Manual (Page 295)

295
On/Standby
(power) light Status
light Laser
light Temp light Filter
light Status and solution
Off Flashing
blue Off Off Orange Low air flow through the projector.
• Make sure that the vents and air
filter are not clogged with dust or
obstructed by nearby objects.
• Clean or replace the air filter.
• If the problem persists, unplug the
projector and contact Epson for
help.
Off Flashing
blue Orange Orange Off Lens Shift error. Turn off the
projector, unplug the power cord, and
contact Epson for help.
Off Flashing
blue Orange Orange Off Lens error or no lens. Install the lens
unit. If the lens unit is already
installed, remove it and then reinstall
it.
If the problem persists, unplug the
projector and contact Epson for help.
Off Flashing
blue Flashing
orange Flashing
orange Off Shutter error. Turn off the projector,
unplug the power cord, and contact
Epson for help.
Flashing blue Varies Varies Flashing
orange Varies High temperature warning. If the
temperature gets too high, projection
will automatically stop.
• Make sure that the vents and air
filter are not clogged with dust or
obstructed by nearby objects.
• Clean or replace the air filter.
Varies Varies Varies Varies Flashing
orange Clean the air filter.
Flashing blue Varies Flashing
orange Varies Varies The laser has a problem. Turn off the
projector, unplug the power cord, and
contact Epson for help.