Epson Pro L30002UNL 30,000-Lumen HDR Pixel-Shift DCI 4K Laser 3LCD Large Venue Projector (White) - Manual (Page 93)

93
8. Select the Priority Gateway setting for your network.
9. If you want to monitor the projector using PJLink, turn on the PJLink setting.
10. If your network environment uses an AMX controller, turn on the AMX Device Discovery setting to
allow the projector to be detected.
11. If your network environment uses a Crestron Connected controller, turn on the Crestron Connected
setting to allow the projector to be detected.
Note: Enabling Crestron Connected disables the Message Broadcasting feature in the Epson
Projector Management software (Windows only).
12. If you want to control the projector using Art-Net (an Ethernet communication protocol based on
TCP/IP), turn on the Art-Net setting.
13. If you want this projector to receive broadcast messages over the network, turn on the Message
Broadcasting setting. Administrators can broadcast messages over the network using the Epson
Projector Management software (Windows only).
14. When you finish selecting settings, select Complete and follow the on-screen instructions to save
your settings and exit the menus.
Parent topic: Using the Projector on a Network
Related concepts
Using Crestron Connected
Related references
Art-Net Channel Definitions
Additional Projector Software and Manuals
Setting a Static IP Address on the LCD Screen
You can set a static IP address on the projector's LCD screen while the projector is in standby mode.
This lets you set the address without needing to project anything.
1. Press the Menu button on the projector or remote control.