Epson Pro L30002UNL 30,000-Lumen HDR Pixel-Shift DCI 4K Laser 3LCD Large Venue Projector (White) - Manual (Page 70)

70
1. Plug in the HDMI cable.
2. Insert the end of the cable clip anchor into the cable clip slot near the HDMI port.
3. Place the open cable clip around the HDMI cable, but don't lock it into place.
4. Slide the cable clip onto the anchor and lock the clip onto the HDMI connector.
To remove the cable clip, open the clip and disconnect the HDMI cable. Then pinch the sides of the
cable clip anchor and carefully pull it out of the cable clip slot.
Parent topic: Setting Up the Projector
Installing Batteries in the Remote Control
The remote control uses the two AA batteries that came with the projector.
Caution: Use only the type of batteries specified in this manual. Do not install batteries of different types,
or mix new and old batteries.
1. Remove the battery cover.