Energy-conservation settings, Introduction, Set the sleep schedule – HP Digital Sender Flow 8500 fn2 Document Capture Workstation User Manual
Page 119
Energy-conservation settings
Introduction
●
Set the sleep timer and configure the scanner to use 2 watts or less of power
●
Configure sleep settings to reduce power usage when the product is idle.
Set the sleep timer and configure the scanner to use 2 watts or less of power
The sleep settings affect how much power the product uses, the wake/sleep time, how quickly the product
enters sleep mode, and how quickly the product wakes up from sleep mode.
To configure the product to use 2 watt or less of power while in sleep mode, enter times for both the
Sleep after
Inactivity
and
Auto Off after sleep
settings.
1.
From the Home screen on the product control panel, select
Settings
.
2.
Open the following menus:
●
General
●
Energy Settings
●
Sleep Settings
3.
Select
Sleep after Inactivity
to specify the number of minutes the product is inactive before it enters sleep
mode. Enter the appropriate time period.
4.
Select
Auto Off after sleep
to put the product into a deeper power save mode after a period of sleep. Enter
the appropriate time period.
NOTE:
By default, the product will wake from Auto Off in response to any activity other than USB or Wi-Fi.
For greater energy settings, you can set it to wake only to the power button by selecting
Shut down (wake
on power button only)
.
5.
Select
Done
to save the settings.
Set the sleep schedule
Use the
Sleep Schedule
feature to configure the product to automatically wake or go into Sleep mode at specific
times on specific days of the week.
1.
From the Home screen on the product control panel, select
Settings
.
2.
Open the following menus:
●
General
●
Energy Settings
●
Sleep Schedule
ENWW
Energy-conservation settings 109