Upgrade the firmware – HP Digital Sender Flow 8500 fn2 Document Capture Workstation User Manual
Page 122
Upgrade the firmware
1.
From the Home screen on the control panel, select the
Reports
option, and then select the
Configuration/
Status Pages
option.
2.
Select the
Configuration Page
option, and then select
View
. The report lists the current firmware revision
number.
3.
, search for your product, and then look for a link to downloads to see if there is a
newer version of firmware available.
4.
Copy the new firmware file to a USB storage device, and then plug the USB device into the USB port beside
the control panel.
CAUTION:
Make sure to leave the USB storage device plugged into the USB connector until all upgrades
are installed, the product has rebooted, and the Home screen is displayed on the control panel.
5.
From the Home screen, select the
Support Tools
option, select
Maintenance
, and then select the
USB
Firmware Upgrade
option.
6.
Select
Firmware Upgrade Bundle
, and then select
Install
.
The upgrade process can take a few minutes. Starting the product after a firmware upgrade might take up
to 20 minutes.
7.
If necessary, repeat the previous two steps to install a second upgrade.
NOTE:
You can also upgrade firmware using the HP Embedded Web Server (EWS). Start the EWS, select the
General tab, select Firmware Upgrade in the left navigation pane, and then follow the onscreen instructions to
download a firmware upgrade directly to the product.
112 Chapter 4 Manage the scanner
ENWW