Teledyne 9110T - Nitrogen Oxides Analyzer User Manual
Page 128
Advertising
Model 9110T NOx Analyzer
Setup Menu
Teledyne Analytical Instruments
128
5.9.3.9. ADDING A RECORDER OFFSET TO AN ANALOG OUTPUT
Some analog signal recorders require that the zero signal be significantly different from the baseline of
the recorder in order to record slightly negative readings from noise around the zero point. This can be
achieved in the 9110T by defining a zero offset, a small voltage (e.g., 10% of span).
To add a zero offset to a specific analog output channel, select the ANALOG I/O CONFIGURATION
submenu (see Figure 5-5) then press:
Advertising