Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 1023)

Backup Services Commands
Page 34-13
Idx . The index number of the backup service.
Description . Enter a description of the backup service in this field. Your description may
consist of a maximum of 30 ASCII characters.
Primary Type . This field shows the type of entity that will be backed up in the case of network
failure. The available options are Physical Port and Frame Relay PVC DLCI .
Slot/Port/Dlci . The slot, port number, and DLCI number (if applicable) attached to this backup
service.
Bkp Type . This field shows the entity type to be used as a backup in the event of primary fail-
ure. At this time, the only available backup type is PPP .
Peer Id . The identification number of the peer that has the backup port for this service.
Current State . The current state of the backup service. The options for this are Primary Up ,
Primary Down , Backup Up , Backup Down , Backup Initiated .
Clearing Backup Service Statistics
To clear the statistics for a backup service, enter the bsclear command as shown:
bsclear b<backupIndex>
where b<backupIndex> is the service index number assigned to the service when it was
created. For example, to clear the statistics for a backup service with an index number of 1,
enter:
bsstatus b1
A prompt similar the following displays:
This will reset the statistic for Backup Index: 1
Continue ? {(Y)es, (N)o} (n) :
Enter y to clear the statistics.