Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 200)

Checking the Flash File System
Page 7-14
Checking the Flash File System
The fsck command performs a file system check of flash memory, which consists of the flash
file system. All image files are stored in flash memory and loaded into system memory when
the switch boots up.
The command also provides diagnostic information in the event of file corruption. To perform
a file system check of flash memory, enter
fsck
at the system prompt. A screen similar to the following will be displayed:
Your bootroms support Flash File System Version 2 and greater.
Out of 16 file descriptors in use, 0 of these are opened on the /flash device.
Performing a file system check using manual mode. If a file is encountered
with a potential problem, you may wish to consider preserving it for technical
support analysis...
Flash file system check in progress...
Checking root file system... OK
Performing file consistency check...
Done.
There doesn't appear to be a system problem related to the Flash File
system or kernel file system data structures. If you are experiencing
problems with the flash file system, perhaps try using the "info",
"systat", or "memstat" commands. They may indicate some other condition
(such as low memory) which could prohibit correct operation of the
file system.
If the fsck command detects a problem with the flash file system, a message will be displayed
indicating the problem, along with any steps needed to resolve it.
Each logical file system must be checked independently.