Alcatel Carrier Internetworking Solutions Omni Switch/Router User Manual

Page 575

Advertising
background image

Creating a New Group

Page 19-33

7) Admin, Operational Status

Select whether to administratively enable or disable this port. When you enable the port,
the port can transmit and receive data as long as a cable is connected and no physical or
operational problems exist. When you disable a port, the port will not transmit or receive
data even if a cable is connected and the physical connection is operational. If you
disable the port at this point, you can enable it later through the

modvp

command (see

Modifying a Virtual Port on page 19-45).

8) Mirrored Port Status

If the port you are configuring is Ethernet (10 or 10/100 Mbps), you can set up port
mirroring. You can mirror traffic on this port to another like port. Port mirroring is a
useful feature for monitoring traffic on particular ports. It is discussed in more detail later
in this chapter in Port Mirroring on page 19-57.

If you want to mirror this port, enter a

8=e

, press

<Enter>

and you will be prompted for

the slot and port number of the “mirroring” port (i.e., the port that can “see” all traffic for
this port):

Mirroring vport slot/port ? ( ) :

Enter the mirroring port’s slot and port number and press

<Enter>

.

If port mirroring is not supported on this port, then the following prompt will display:

mirroring not supported on this port type

9) MAC address

Enter the MAC address for this virtual port if it is known.

After the MAC address prompt, the switch confirms the addition of the port to the group
with a message similar to the following:

Adding port 2/8 to Group 6. . .

Make configuration changes to the port until you are satisfied. If you have completed the
final virtual port, then your work is complete. You can always alter Group parameters
(including virtual router parameters for the default

VLAN

) later through the

modvl

command (see Modifying a Group or VLAN on page 19-40) and modify virtual port param-
eters through the

modvp

command (see Modifying a Virtual Port on page 19-45).

Advertising