Removing an ip static route, Removing an ip static route -19 – Alcatel Carrier Internetworking Solutions Omni Switch/Router User Manual
Page 741
Removing an IP Static Route
Page 25-19
Removing an IP Static Route
The
risr
command is used to remove IP static routes from the switch’s IP Forwarding Table.
Follow the steps below to remove an IP static route.
1. Enter
risr.
The prompt that displays depends on whether routing domains are configured
on the switch. For more information about routing domains, see Chapter 14, “Routing
Domains,” in the Advanced Routing User Manual.
If routing domains are configured on this switch, the following prompt displays:
Routing Domains (RD) are configured on this switch.
List the RD(s) you want this route applied to? (default: none) :
If you are removing a route from an existing domain, press
Enter
. To remove a route from
an existing routing domain, enter the desired routing domain ID (
RDID
) and go to step 3.
If routing domains are not configured on this switch, or if you are applying this route to
the default domain, the following prompt displays:
Do you want to see the current route table? (y or n) (y) :
2. Enter a
y
at this prompt (or just press
<Enter>
) to display the current forwarding table.
A screen similar to the following displays:
IP FORWARDING TABLE
Group VLAN
Network
Mask
Gateway
Metric
Id:
Protocol
------------------------------------------------------------------------------------------------------------------------
0.0.0.0
255.0.0.0
198.206.184.254
1
1:1
STATIC
10.0.0.0
255.0.0.0
10.0.0.1
1
6:1
STATIC
11.0.0.0
255.0.0.0
11.0.0.1
1
5:1
STATIC
90.0.0.0
255.0.0.0
90.0.0.3
1
4:1
STATIC
127.0.0.0
255.0.0.0
127.0.0.1
0
1:2
LOOPBACK
127.0.0.1
255.255.255.255 127.0.0.1
0
2:3
LOOPBACK
196.196.7.0
255.255.255.0
196.196.7.42
1
3:1
RIP
198.206.187.0 255.255.255.0
198.206.183.0
1
1:4
STATIC
198.206.184.0 255.255.255.0
198.206.184.42
1
1:1
RIP
203.229.229.0 255.255.255.0
203.229.229.250
1
2:1
RIP
Destination IP address of host or network :
3. At the prompt for the destination IP address, enter the IP address of the host or network
that you want to remove.
4. A prompt similar to the following displays:
Host or network mask (255.255.255.000) :
Enter the mask (or just press
<Enter>
to accept the default mask).
5. The following prompt displays:
IP address of next hop :
Enter the IP address of the next hop (the gateway) router to the destination IP address.
A message will confirm the deletion of the static route:
Route successfully deleted