Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 84)

Gigabit Ethernet Modules
Page 3-14
2-Port Advanced Gigabit Ethernet Switching Module
Port
LEDs
LINKTX RX
1
2
RX
TX
RX
TX
1
2
LINK (Link Status/Disabled).
On Green when the corre-
sponding port has a valid phys-
ical link and a signal is present.
Under normal conditions, this
LED should always be on when
a cable is connected.
TX (Transmit). On Green when
the corresponding port is trans-
mitting data.
RX (Receive). On Green when
t h e c o r r e s p o n d i n g p o r t i s
receiving data.
This Gigabit Ethernet module
includes one row of LEDs for each
port. The LEDs for a given port dis-
play in the row labeled with the
port number. Definitions for the
LEDs are given below.
OK1
OK2
GSX-K sm Module Label . This label will indicate
the GSX-K-FM/FS/FH-2W type. It
will read either
GSX-K mm ( multimode
cable ), GSX-K sm (intermediate-reach
single mode cable), or GSX sm K
long reach ( long-reach single-mode
cable ).
SC connectors will be color
coded to indicate multimode
(Black) or intermediate-reach
single mode (Blue).
CLASS 1 LASER PRODUCT
Warning Label . This label indicates
that the module contains an optical
transceiver.
Module
LEDs O K 1 ( H a r d w a r e S t a t u s ) . O n
Green when the module has
passed diagnostic tests success-
fully. On Red when the hardware
has failed diagnostics.
OK2 (Software Status). Blinking
Green when the module soft-
ware was downloaded success-
f u l l y a n d t h e m o d u l e i s
communicating with the
MPX .
Blinking Red when the module is
in a transitional state. On solid
R e d i f t h e m o d u l e f a i l e d t o
download software from the
MPX .