Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 460)

Bridging Commands
Page 17-12
2. To modify an entry, use the index number for the specific static bridge address (listed in
the leftmost column), the column letter for the column you want to change, an equal sign,
and a new value. For example, to change the
Static Status of the first address’s in the table
from permanent to deleteOnReset , you would enter a 1 (the static bridge address Index
number), a b (the column letter for Static Status ), an equal sign ( = ), and the number 4 (the
value for deleteOnReset ), as shown:
1b=4
3. Press <return> to complete the operation.
4. Type save at the fc command prompt to save the changes.
Deleting a Static Bridge Address
Deleting a previously created static bridge address is much the same process as modifying a
Static Bridge Address. To delete a Static Bridge Address, follow these steps:
1. Enter the fc command as documented above. The Bridge Static Address table will display
as shown:
Bridge Static Address for Group 2 (Default GROUP (#2))
Index MAC Address Slot/Intf/Service/Inst Static Status
(A) (B)
-------- ----------------------- ------------------------------ ---------------------
1 21A33E:00B001 3/ 1/ Brg/1 permanent
2 001122:223344 3/ 2/ Brg/1 deleteOnReset
The entries can be modified by specifying the index and column.
For Static Status, use 2 to delete, 3 for Permanent,
4 for Delete on Reset, 5 for Delete on Timeout
To add an entry: Use command 'add MAC addr, receiving port, static status'.
Receiving port and Status must be provided.
Port could either be slot/intf or virtual port begin with v.
For non-canonical MAC format add 'nc' before MAC.
ie: add 123456:7890AB, 2/3, 3 or add nc001122:334455, v99, 3
NOTE: add command will be executed immediately.
save|cancel|next only applies to existing entry.
add|save|cancel|next :
2. To delete an entry, use the index number for the specific static bridge address, the
column letter b (the column letter for Static Status ), an equal sign ( = ), and a 2 (the value
for Delete ).
For example, to delete the first address in the table, you would enter a 1 (the static bridge
address Index number), a b (the column letter for Static Status ), an equal sign ( = ), and the
number 2 (the value for Delete ), as shown:
1b=2
3. Press <return> to complete the operation.
4. Type save at the fc command prompt to save the changes. The Static Status will change to
Invalid . Once you exit the fc command, the Static Bridge Address is removed from the
table.