Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 933)

Configuring a WAN Routing Service
Page 29-61
6. Specify the Group number to which this router port belongs. Enter a 5, an equal sign (=),
and the Group number. The example below includes Group 4 in the routing service:
5=4
Press <Enter> .
You must have previously configured this Group as a Frame Relay Routing Group through
the
crgp command. If you have not configured the Group for Frame Relay routing, then
the following message displays:
Given Vlan Group is not a Frame-Relay Router Group
See the section, Step 1. Set Up a Frame Relay Routing Group on page 29-59 for further
information on setting up a Frame Relay Group.
7. Disregard the Frame-Relay Bridging Mode field. It does not apply to virtual router ports.
8. Type save at the colon prompt (:) and press <Enter> . All parameters for this bridging
service are saved.