Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 767)

UDP Relay Configuration Screen
Page 26-3
UDP Relay Configuration Screen
To configure any of the UDP relays, use the relayc command. The relayc command is listed in
the IP submenu. (For more information about IP commands, see Chapter 25, “IP Routing.”)
The screen display is similar to the following:
UDP Relay Configuration
1) BOOTP/DHCP Enabled : No
2) NBNS Enabled : No
3) NBDD Enabled : No
4) +Generic Services Menu
Command {Item=Value/?/Help/Quit/Redraw/Save} (Redraw) :
Use the UDP Relay Configuration screen to enable any of the relays and display more config-
uration options for enabled relays. The following sections describe each
UDP service and how
to configure each of the relays using the User Interface (UI). A UDP statistics screen may also
be displayed.
♦ Note ♦
For general information about the UI, see Chapter 4,
“The User Interface.”