Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 325)

Configuring SNMP Parameters and Traps
Page 13-5
Here is a sample configuration for setting a combination of traps.
Bit Configurations for Setting Traps
Example: To set a combination of trap types, add the hex values of the bits as follows:
You would then enter the total mask value of the traps, as follows:
Enter trap mask words 0:1 (ffffffff:ffffffff): 0000C000:00000201
This setting would enable only these four traps for words 0 and 1.
b. The following prompt displays:
Enter trap mask words 2:3 (ffffffff:ffffffff):
Enter the trap type(s) for words 2 and 3. If you want to accept the default (all traps
enabled for words 2 and 3), press
<Enter> . To set one or more specific traps, again calcu-
late the bit configurations and enter the new mask value at the prompt.
c. The following prompt displays:
Enter destination port (162):
Enter the UDP destination port for the traps configured above. If you choose the default in
field four, port 162, press <Enter> at the prompt.
d. The following prompt displays:
NMS state (on):
Indicate whether or not traps will be sent to this Network Management Station (the NMS
defined in step a). If the
NMS state is enabled ( on ), the NMS will be notified of traps. Press
< Enter > to accept the default ( on ). If the NMS state is disabled ( off ), the NMS will not be
notified of traps.
word 0 (4 bytes)
bit 0
00 00 00 00 : 00 00 00 00
bit 0
word 1 (4 bytes)
Trap Type Bit Settings
Word 0 Word 1
tempAlarm 00 00 00 00 : 00 00 00 01
risingAlarm 00 00 40 00 : 00 00 00 00
fallingAlarm 00 00 80 00 : 00 00 00 00
portPartitioned 00 00 00 00 : 00 00 02 00
Total = 00 00 C0 00 : 00 00 02 01