Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 576)

Creating a New Group
Page 19-34
Step 5. Configuring AutoTracker Policies (Mobile Groups Only)
When you have completed configuring mobile group and auto-activated LANE services, you
can begin configuring AutoTracker policies for this mobile group. Instructions for configuring
these rules can be found in Chapter 20, “Configuring Group and VLAN Policies.” Please refer
to that chapter for instructions on configuring each policy type. After you configure
AutoTracker policies, you are done configuring this mobile group and a prompt similar to the
following displays:
VLAN 9: 1 created successfully
You can configure rules for this group later through the modatvl command. This command
also works with mobile groups as long as you indicate you want to alter VLAN 1 in the
mobile group (i.e., the command line would read
modatvl 3:1 to modify mobile group 3).
♦ Note ♦
If the mobile group is initially created without rules, the
modatvl command cannot be used to add them later.
You must turn off group mobility and then reinstate it
to add the rules.