Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 950)

Adding a PPP Entity
Page 30-12
Enabling Routing expands the menu with the following suboptions:
6) Routing Group . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
{1-65535 or 0 if no Routing}
60) IP Config Admin Status . . . . . . . . . . . . . . . . . . . . . . . . . Enabled
{(E)nabled, (D)isabled}
61) Remote IP Address (Only valid if IP is enabled) . . . . . 0.0.0.0
{Valid IP address notation e.g., x.x.x.x}
62) IPX Config Admin Status . . . . . . . . . . . . . . . . . . . . . . . . Enabled
{(E)nable, (D)isable}
The suboptions under this heading are:
IP Config Admin Status
Used to enable or disable the routing of IP packets over PPP. The options are Enabled and
Disabled .
Remote IP Address (Only valid if IP is enabled)
Used to specify the Remote IP address of the PPP connection when IP routing is enabled.
Valid IP address notation must be used. If this parameter is set to 0.0.0.0 and IP routing is
enabled, the Remote IP address will be learned during Internet Protocol Control Protocol
(IPCP) negotiation.
IPX Config Admin Status
Used to enable or disable routing of IPX packets over PPP. The options are Enabled and
Disabled .
Authentication Type
Indicates the type of authentication to be used by this PPP Entity. The options are None , PAP ,
and CHAP .
Enabling Authentication expands the menu with the following suboptions:
7) Authentication Type. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PAP
{(N)one, (P)AP, (C)HAP}
70) User ID received from remote for Authentication . . .
{8 characters userid}
71) Password received from remote for Authentication .
{8 characters password}
72) User ID sent to remote for Authentication. . . . . . . . . .
{8 characters userid}
73) Password sent to remote for Authentication . . . . . . .
{8 characters password}
The suboptions under this heading are:
User ID received from remote for Authentication
Used to specify the User ID to be expected from the remote end during PAP or CHAP
authentication.
Password received from remote for Authentication
Used to specify the password to be expected from the remote end during PAP or CHAP
authentication.