Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 459)

Bridging Commands
Page 17-11
Field Descriptions
The following section describes the fields in the fc command table.
Index. A number assigned to the row to identify a previously created static bridge address,
when modifying the address.
MAC address. The canonical MAC address for this static bridge.
Slot/Intf/Service/Inst. The slot number, interface (port) number, type of service, and service
instance. For example, a bridge service on port 1 of slot 3 would be:
3/1/Brg/1
Static Status. The status of the static MAC address as determined when created. The Status will
be one of the following:
Invalid This entry was deleted within the current session.
Permanent This entry is in use and will remain so until it is deleted from the
table. See Deleting a Static Bridge Address on page 17-12 for
specific information.
deleteOnReset This entry is in use and will remain so until the bridge is reset.
deleteOnTimeOut This entry is currently in use and will remain so until it is aged out.
Modifying a Static Bridge Address
Once you have created a static bridge address, you can modify its interface assignment or its
status. To modify a static bridge address:
1. Enter the fc command as documented above. The Bridge Static Address table will display
as shown:
Bridge Static Address for Group 2 (Default GROUP (#2))
Index MAC Address Slot/Intf/Service/Inst Static Status
(A) (B)
-------- ----------------------- ------------------------------ ---------------------
1 21A33E:00B001 3/ 1/ Brg/1 permanent
2 001122:223344 3/ 2/ Brg/1 deleteOnReset
The entries can be modified by specifying the index and column.
For Static Status, use 2 to delete, 3 for Permanent,
4 for Delete on Reset, 5 for Delete on Timeout
To add an entry: Use command 'add MAC addr, receiving port, static status'.
Receiving port and Status must be provided.
Port could either be slot/intf or virtual port begin with v.
For non-canonical MAC format add 'nc' before MAC.
ie: add 123456:7890AB, 2/3, 3 or add nc001122:334455, v99, 3
NOTE: add command will be executed immediately.
save|cancel|next only applies to existing entry.
add|save|cancel|next :