Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 71)

Page 3-1
3 Omni Switch/Router
Switching Modules
Omni Switch/Router switching modules perform software filtering, translations between
dissimilar network interfaces, and hardware-based switching. Omni Switch/Router switching
modules have an additional on-board interface connector for the
HRE-X .
Currently, Omni Switch/Router switching modules consist of Gigabit Ethernet modules, auto-
sensing 10/100 Ethernet modules, Fast (100 Mbps) Ethernet modules, 10 Mbps Ethernet
modules,
Voice Over IP (VOIP) modules, and WAN modules.
♦ Important Note ♦
Omni Switch/Router modules require the use of an
Omni Switch/Router chassis (see Chapter 1, “Omni
Switch/Router Chassis and Power Supplies”). Do not
install an Omni Switch/Router module in an
OmniSwitch chassis and do not install an OmniSwitch
module in an Omni Switch/Router chassis.
Gigabit Ethernet Modules
• GSX-K-FM/FS/FH-2W Advanced 2-port Gigabit Ethernet switching module
10/100 Ethernet Modules
• ESX-K-100C-32W Advanced 32-port auto-sensing 10/100 Ethernet switching
module
Fast (100 Mbps) Ethernet Modules
• ESX-K-100FM/FS-16W Advanced 16-port Fast Ethernet (100 Mbps) switching module
WAN Modules
• WSX-S-2W 2 serial ports that support the frame relay or PPP protocol.
• WSX-SC-4W/8W 4 or 8 serial ports that support the frame relay or PPP protocol.
• WSX-FT1/E1-SC-1W/2W 1 or 2 T1 / E1 ports and one or two serial ports that support the
frame relay or PPP protocol
• WSX-BRI-SC-1W/2W 1 or 2 UPS (Universal Serial Port) and 1 or 2 ISDN-BRI ports that
support Frame Relay or PPP
Voice Over IP Modules
Voice Over IP ( VOIP ) modules for the Omni Switch/Router are listed below and are docu-
mented in the VoIP User Manual.
• VSX-A 4, 6, 8, 14, or 16 analog RJ-11 ports supporting FXS and FXO
interfaces, including T.38 FAX
• VSX-VSD 2 or 4 digital T1 or E1 (Euro PRI and Qsig) ports, including
T.38 FAX