Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 79)

Diagnostic Tests
Page 3-9
9. If the hot swapping mode has not timed out, enter
swap off
at the system prompt. Something like the following will then be displayed.
Swap is OFF, timeout is 5 minutes
usage swap { ON [ minutes ] | OFF [ minutes ] }
Diagnostic Tests
All switching modules are subjected to extensive power-on diagnostics during the Power-On
Self-Test cycle (
POST ). These diagnostics are designed to be as extensive as possible without
causing disruption to external networks or requiring special test connections. While the diag-
nostics are running, the
MPX OK2 LED will be flashing green. LED s on the switching module
can provide information on the success or failure of these tests. Also refer to Chapter 35,
“Troubleshooting,” for information on error conditions reflected in the
LED displays.
More extensive diagnostic tests are available for off-line testing of switching modules. See
Chapter 36, “Running Hardware Diagnostics,” for further information.