Alcatel Carrier Internetworking Solutions Omni Switch/Router User Manual
Page 626
Defining and Configuring AutoTracker Policies
Page 20-10
Protocol Specified by Ether-Type
a. To specify a protocol by Ethernet type, enter
5
at the
Select Protocol:
menu. The follow-
ing prompt displays:
Enter the Ether-type value in hex:
b. Enter the desired Ethernet type in hex. You must enter two bytes of data. For exam-
ple, enter 0800 to specify
IP
or enter 0806 to specify
ARP
. All devices that use the
specified Ethernet type will be members of the mobile group or AutoTracker
VLAN
.
c. Go on to Step 4 below.
Protocol Specified by DSAP and SSAP
a. To specify a protocol by
SAP
(service access protocol) header, enter
6
at the
Select
Protocol:
menu. The following prompt displays:
Enter the DSAP value in hex:
b. Enter the destination service access protocol (
DSAP
) value in hex and press
<Enter>
.
The following prompt displays:
Enter the SSAP value in hex:
c. Enter the source service access protocol (
SSAP
) value in hex. Each entry must consist
of one byte of data. All devices that use the specified source and destination
SAP
types
will be members of the mobile group or AutoTracker
VLAN
.
d. Go on to Step 4 below.
Protocol Specified by SNAP
a. To specify a protocol by
SNAP
(sub-network access protocol) type, enter
7
at the
Select
Protocol:
menu. The following prompt displays:
Enter the SNAP value in hex
b. Enter the desired
SNAP
value in hex. You must enter five bytes of data. For example,
enter
0000008137
to specify
IPX SNAP
or enter
00000080F3
to specify AppleTalk
ARP
SNAP
. All devices that use the specified
SNAP
type will be members of the mobile
group or AutoTracker
VLAN
.
c. Go on to Step 4 below.
4. The following prompt displays:
Configure more rules for this vlan (y/n):
You can set up multiple rules for the same mobile group or AutoTracker
VLAN
. Enter a
Y
here if you want to set up more rules in addition to the protocol rule specified here. If
you enter
Y
, you will be prompted for the next rule that you want to set up. Follow the
directions in the appropriate section to configure that rule.
If you enter
N
, you will receive a message, similar to the one below, indicating that the
VLAN
was set up.
VLAN 1:2 created successfully
You are done setting up rules for this mobile group or AutoTracker
VLAN
.