Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 991)

The T1/E1 Menu
Page 33-3
The T1/E1 Menu
The commands for configuring and monitoring T1 and E1 ports are contained in the te
submenu. This submenu displays as shown below and may be accessed (when in verbose
mode) by entering
te at a system prompt.
Command T1/E1 Port Management Menu
-------------- --------------------------------------------------------
tes View status of a T1/E1 port configuration and statistics
temod Modify a T1/E1 port configuration
tecls Clear framer statistics of a T1/E1 port
telts Display 24-hour period statistics of a local T1/E1 port
telcs Display current 15-minute statistics of a local T1/E1 port
telis Display 15-minute interval statistics of a local T1/E1 port
terts Display 24-hour period statistics of a remote T1/E1 port
tercs Display current 15-minute statistics of a remote T1/E1 port
teris Display 15-minute interval statistics of a remote T1/E1 port
tebcfg Configure BERT test
tebs Display BERT statistics
tebcls Clear BERT statistics
tecfg Configure T1/E1 port type
The commands in this menu are described in the following sections. The first command, tes ,
displays configuration information on ports. This configuration information is configured
through the
temod command. The remaining commands, listed after the telts command
provide a variety of interval statistics for local and remote T1 and E1 connections.
♦ Note ♦
The tebcfg , tebs , tebcls , and tecfg commands apply
only to the OmniAccess 408 and 512. For the Omni
Switch/Router, these are nonfunctioning commands.