Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 782)

NetBIOS Relays
Page 26-18
Forwarding VLANs for NBDD Relay
You may select or deselect VLANs to which the NBDD relay will forward. At least one forward-
ing VLAN (or a next-hop address as described in Next-Hop Addresses for NBDD on page 26-17)
must be configured for the relay.
To select forwarding VLANs for NBDD relay:
1. On the command line of the UDP Relay Configuration screen, enter the following:
32=a
A screen similar to the following displays:
Available/Selected VLANS
Item Group ID:VLAN ID MASK IP ADDR
1) 1:1 255.255. 0. 0 172. 23. 9.105 *
* = selected for forwarding
Enter item number of VLAN to be selected [‘h’f or help/<ret> to exit] :
2. Enter the item number of the group/ VLAN that you want to select. Repeat this step for all
the groups/ VLANs you want to select.
3. Press <Enter> to return to the command line for the UDP Relay Configuration screen.
4. Enter s to save the changes.
To deselect forwarding VLANs:
1. On the UDP Relay Configuration screen, enter
32=d
The Available/Selected VLANs screen displays. Asterisks indicate VLANs selected for
forwarding.
2. Enter the item number of the group/ VLAN that you want to deselect. Repeat this step for
all the groups/ VLANs you want to deselect.
3. Press <Enter> to return to the command line for the UDP Relay Configuration screen.
4. Enter s to save the changes.