Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 965)

Adding a WAN Link
Page 31-5
2. You must now change the Link Type to ISDN. To do so, enter the following commands:
: 3=I
: ?
A screen similar to the following displays:
1) Link Description :
{Enter text up to 31 characters}
2) Link Administrative Status . . . . . . . . . . . . . . . . . . . . . . . . . . = Enabled
{(E)nabled, (D)isabled}
3) Link Type. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . = ISDN Call
{(W)SM Port, (I)SDN call}
4) Link Slot. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . =
{Slot number or 0 if not tied to a slot}
5) Link Port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . =
{Port number or 0 if not tied to a port}
(save/quit/cancel)
:
3. You must now enter the ISDN slot and port numbers that will be used by this WAN Link.
For example, to use slot 4, port 2, you would enter the following commands:
: 4=4
: 5=2
Note
Incoming and backup ISDN calls may dynamically
select and use any available slot and port. However,
you must specify an ISDN slot and port for the link
when you first create its WAN Link.