Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 800)

Adding an IPX Static Route
Page 27-12
Adding an IPX Static Route
The aipxsr command is used to add IPX static routes to the switch’s IPX Routing Table. You
might want to add a static route to send traffic from a node in an Omni Switch/Router VLAN
to an external IPX network address (such as an address reached through an external network
router attached to the switch).
In order to add a static route, you will need to know the host/net and the gateway which will
be used to route traffic there.
Follow the steps below to add an IPX static route.
1. Enter aipxsr.
A screen similar to the following displays:
Do you want to see the current route table? (y or n) (y) :
2. Enter y at this prompt (or press <Enter> ) to display the current routing table.
A screen similar to the following displays:
Displaying all (4) routes:
Dest Net Router Hops Delay Static Aged Redir Chg Dir GP:VL
3333 e8024.0000c021a5b8 1 3 N Y N N N 7:1
5555 5555.Direct 0 1 N N N N Y 4:1
e8024 e8024.Direct 0 1 N N N N Y 7:1
3041c204 e8024.0000c021a5b8 1 3 N Y N N N 7:1
Destination IPX network :
Enter the IPX address of the network to which you are setting up a route.
3. The following prompt displays:
IPX network of next hop :
Enter the IPX network address of the next hop. This is the number that appears before
the dot under the “Router” heading in the IPX Route Table.
4. The following prompt displays:
IPX node address of next hop (format - xx:xx:xx:xx:xx:xx)
Enter the IPX node address of the next hop.
5. A message will confirm the addition of the static route:
Route successfully added