Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 121)

UI to CLI Command Cross Reference
Page 4-11
WAN Access Commands
The table beginning on page 4-11 summarizes the features supported in the UI and the CLI for
Chapters 28 through 34.
WAN Access Table
Chapter UI Command Equivalent CLI Commands PM Family
28, “WAN
Switching
Modules” wpadd
wpdelete aaa 10-WAN
29,
“Managing
Frame Relay” fradd, frmodify
frmodify
dlci
description
status
cir bc be
bridge-group
bridgepmode
bridge check fcs strip
routing-group
trunking-group
payload-compress FRF9 stac
interface
clock source
clock rate
lmi-type
intf-type
lmi-t391 dte
lmi-n391 dte
lmi-n392 dte
lmi-n393 dte
lmi-n392 dce
lmi-n393 dce 10-WAN
30,
“Point-to-Point
Protocol (PPP)” pppglobal
pppadd, pppmodify
ppp-global authentication
ppp-global sent-username
ppp-global compress
ppp-global bridging status
ppp-global ip config admin
status
ppp-global ipx-status
interface
encapsulation ppp
description
status
multilink
compression
bridge-group
bridging
bridge-mode
bridge-check fcs strip
routing-group
ip status
remote ip
ip-address
ipx-status
authentication
local-username
sent-username
max failure
max configure
max terminate
retry timeout value 10-WAN
continued on next page...